Why does the burner automatically turn off after ignition?
In general, unless affected by environmental factors such as strong winds, heavy rain, and other unpredictable factors, the burner will not be deactivated during use. So what causes the ignition device to automatically turn off? In fact, the impact of small makeup is not fully summarized, so the following points are introduced.
Combustion machine accessories:
1. The internal combustion engine controller has no induction problem and cannot detect the internal combustion engine flame signal, resulting in ignition failure. Because the induction controller is an ion probe and an ultraviolet eye, its sensitivity to flame signals is relatively low.
2. Signal line transmission failure
3. Process controller is interfered with, resulting in malfunction
4. The ignition flame itself is too weak to ignite the burner.
5. Improper operation results in incorrect connection between the zero line and the ground wire, and unstable connection of the ground wire.
6. Gas supply issues, such as gas supply being less than the combustion port, gas shortage, and impure gas.
7. The temperature sensor in the burner component is faulty.
8. The pump has a series of problems, such as sticking, damage, etc.
9. Burner computer board failure
10. Faults caused by excessive temperature
11. Insufficient combustion air volume
12. Air valve blockage
The above is about the issue of combustion engine accessories caused by the ignition failure of the combustion engine, and the methods used to extinguish the influencing factors. If you have any questions, please leave a message in the comments section.